Circular formwork repair

When using building circular formwork, it is inevitable to encounter various situations, which is unpredictable, but can be avoided. We need to know more about relevant knowledge. Of course, problems can also be dealt with, such as formwork supply -- how to repair the corner warping of building circular formwork.

We know that is more rain in the south, the north edge is dry, so under the condition of the two extremes of construction must be more careful, you know fangyuan mould production buildings cylindrical formwork material of wood products, if can not contact the rain for a long time, although the quality of our building formwork is stable, can short time, long steel formwork is also not line, for construction unit it is necessary to find a storage warehouse, moreover, the cylindrical wooden formwork are vertical storage, this way can save a lot of space, shard deposit is very flexible.

Before the frame column is installed, it is necessary to pop out the axis of the column and the surrounding edges on the layer first. For the through row formwork, it is necessary to install the column formwork at both ends first, correct and fix it, and pull through the column formwork in the middle of the long line support.

The beam bottom formwork is made of multi-layer board and wood square, the side board is made of multi-layer board and wood square, and the beam side mold is made of multi-layer board.

When laying the plate bottom formwork, the gap shall be formed without gap by adhesive tape to prevent the leakage of slurry.

In the process of setting up the platform, temporary fixing measures should be set up to prevent overturning.

According to the requirements of woodworking lofting, the vertical and horizontal control lines pop up on the plane, and the operators arrange the support rods according to the control lines to unify the vertical and horizontal spacing.

Also, it should be noted that the formwork is not allowed to contact the steel bar and the wire binding the steel bar, should be placed on the surface of the steel bar prefabricated mortar pad.

If cylindrical steel formwork is used for building circular formwork, considering the cost, the steel formwork is calculated by tons, thousands of pieces per ton, but in theory, the steel formwork can be infinite turnover, a purchase, has been used;

Considering from the construction speed, the steel formwork needs to use tower cranes and other hoisting equipment in the construction process. The installation schedule of the project is affected by the number of tower cranes.

From the perspective of labor cost, the steel formwork still needs 3-4 people to cooperate with the tower crane, and 4-5 columns can be installed at most every day.

From the modeling of special parts encountered in the process of die support, such as bridge column parts and special arc formwork, it takes a lot of manpower and methods to realize the die support of these parts by using steel formwork.