How to save circular column wood formwork for circular columns?Reduce the cost of circular column wood formwork

How to save circular column wood formwork for circular columns?Reduce the cost of circular column wood formwork

One: the use amount of circular column wood formwork should be calculated accurately before ordering.Too much or too little usage calculation will result in waste of materials. Too many formworks will not be used up, too few materials will not be used up, and the quantity of orders must be added, resulting in waste of logistics cost and time cost.Accurate statistics of the number of columns in each floor, height, according to The Times of turnover and consumption of the appropriate order.Two: when using multi-node construction of circular column wood formwork, it is necessary to proceed from the overall situation and accurately plan the size of other floor nodes. Uniform cutting and matching die shall be carried out according to the required size of all floor nodes.Stack the cut formworks in a centralized manner, and repair the formworks that need to be repaired with the cut waste.The cutting staff of circular column wood formwork should have certain woodworking saw cutting experience, in the cutting strictly according to the standard operation, avoid cutting bad, cutting off, resulting in cutting waste.Again: circular column wood formwork of the concave and convex groove interface, cutting surface, perforating surface for paint processing, to prevent a long time after placing the formwork water bloating deformation.Generally before the delivery will be the concave and convex groove interface for spraying treatment, in the site of secondary processing appropriate waterproofing treatment of the cut surface can effectively avoid the use of material waste.The matching steel belt and screw screw of the circular column wood formwork shall be properly kept after use. The supporting reinforcement shall be counted accurately when not in use and stacked separately. The screw screw shall be screwed on the steel belt to avoid loss.Three: the accessories in the process of disassembling and assembling shall not be thrown about, while disassembling the mold, the side disassembling into the bag storage.When the circular formwork is dismantled, it is not allowed to hit hard and fall from high altitude. After removal, it should be timely maintained. Partial damaged formwork should be timely repaired.Through the above steps, it can be realized that both before purchase and during construction, the circular pillar wood formwork can be effectively saved, which naturally can reduce the construction cost of the circular column wood formwork to a certain extent.